Power cord bending/rocking tester

XL-DZY3A/B Power cord bending/rocking tester

Test standards：UL/CSA, GB, IEC, JIS and other relevant domestic international standard "soft line components and power supply cord" regulations are designed and manufactured.

Application range：:This machine is suitable for bending test of power cord/plug wire/cable of non-reconnect plug and household electrical appliance and similar electric appliance. Electrical appliances (plug, hair dryer, vacuum cleaner, etc) fixed on the machine rotating plate, make the power cord exit on the rotating plate center, vertical down the power cord, and hanging load, set the flex around speed, Angle and number of times, then start turning plate and  began to bend the power cord,  examining  damage of coating and the break rate of conductor after stop automatically..

Technical parameters：

1、power：AC 220V  50Hz。　　　　　　　　

2.、Fold frequency: electronic, 10 ~ 60 + 2 / min adjustable 

3、swim angle：10～180±2degree，adjustable(EX factory: left-right±90 degree)。　

4、Test station: 3 sets.

5、number of folding ：A total of 4 counters. One of them is the total number of bending 0 ~ 999999 can be preset, and the remaining three for the test station count for each station of the sample from the beginning of the test to the number of times to break the count.

6、weight of load：50g、100（/113）g、200g、300（/284）g、500g,3 pieces for each kind.

7、fixture group：

 1）for wire:Rotating plate:: Ф105mm,12mm thick（optional, type B）；

 2）for end of plug and connector:Frame type. (optional, type A).